Masonry repair
Sweep & inspection
Caps & crowns
Flue relining
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Olympia Chimney Chimney Repair in Houston: What to Know First
Olympia Chimney repair in Houston typically runs $180 to $2,400 depending on what failed, and most jobs are completed in a single visit. We’re an independent Olympia Chimney service provider; we repair, rebuild, and waterproof Olympia chimney systems across Houston, and we give you a written price before any work starts. No guessing, no surprise on the invoice.
This page is for Houston homeowners who own a home with Olympia Chimney components and need straight answers about repair. If you’re seeing water stains on the ceiling near the chimney, crumbling mortar on the brick, or rust stains on the chimney cap, call us at (325) 750-6259. Hank Delano and our crew have been servicing Houston chimneys for over a decade.
How Olympia Chimney Products Fail – and How We Fix Them
Olympia Chimney makes solid products, but Houston’s humidity and heat expose weak points just like any brand. Here’s what we actually see on service calls and what we do about it:
- Olympia stainless steel chimney liners pull apart at the seam welds. The constant thermal cycling in Houston, hot afternoons followed by air-conditioned interiors, causes expansion and contraction stress at the lap seams. We see this most often on older Olympia rigid liners installed before 2010. Our fix is a full inspection, then either seam repair with high-temp stainless fasteners or a complete reline using a current-spec liner.
- Galvanized Olympia chase covers corrode at the corners. Houston gets 50 inches of rain a year, and galvanized covers eventually rust through at the folded corners. Once the cover fails, water drops straight onto the firebox and damper assembly. We replace them with stainless steel, not another galvanized cover, so the repair actually holds.
- Olympia multi-flue caps with mesh screens clog with creosote and debris. The 3/4-inch mesh on Olympia caps is fine enough to stop birds, but it also catches wind-blown leaves, creosote flakes, and Houston pollen. A clogged mesh restricts draft and pushes smoke back into the house. We remove, clean, and reinstall the cap, and we’ll tell you honestly if the mesh is too far gone to save.
- Olympia terra cotta flue liners crack from water absorption and freeze-thaw. Even in Houston, occasional winter dips below freezing combined with saturated clay liners cause spalling and vertical cracking. A cracked terra cotta liner is a fire hazard because it allows heat and gases to reach the surrounding masonry. The fix is either a HeatShield resurfacing system applied inside the existing liner or a full stainless reline depending on the damage extent.
- Olympia cast-in-place refractory panels deteriorate in prefabricated fireboxes. On Olympia prefab units from the 1990s and early 2000s, the refractory side and back panels are thinner than today’s standards and crumble after years of heat. We replace them with current refractory panel systems sized to the original Olympia firebox dimensions.
Styles & brands we work with
Our Olympia Chimney Chimney Repair Process
Every Olympia chimney job we do in Houston follows the same sequence, and you’ll know the price before step four:
- 1
You call or book, and we schedule a window. A live person answers, day or night. We give you an arrival window and our tech shows up inside it.
- 2
We run a Level 1 or Level 2 camera inspection. A full video scan of the flue, smoke chamber, and firebox. You see the footage with us and we point out exactly what’s wrong before touching a tool.
- 3
We write the scope and price. Parts, labor, access, cleanup. If an Olympia-specific part is available, we use it. If an aftermarket part matches or exceeds OEM spec at a lower cost, we name it and let you decide. We never swap parts silently.
- 4
The repair happens. Mortar repointing, flashing replacement, relining, waterproofing, whatever the camera showed. Clean drop cloths, no mess left on your floor.
- 5
We test the system. Draft check, smoke test if needed, and a final camera pass to document the repaired condition.
- 6
You get the 365-Day Done Right Promise in writing. If the covered repair fails within one year, we come back at no charge. A free return visit, no argument.
What Olympia Chimney Chimney Repair Costs in Houston
Here’s what Houston homeowners can expect to pay for common Olympia chimney repairs:
- Flashing repair: $280 – $650, depending on chimney height and whether the existing flashing is salvageable.
- Crown resealing or rebuilding: $350 – $900. A cracked crown is one of the most common Olympia chimney failure points we see in Houston.
- Mortar repointing (tuckpointing): $20 – $40 per square foot of masonry surface. Most partial chimney repointing jobs land between $600 and $1,400.
- Chase cover replacement (prefab units): $400 – $1,100 including materials and installation, with stainless steel as our standard recommendation.
- Chimney waterproofing: $400 – $800 for a full application of a vapor-permeable masonry water repellent, which is what you actually want because it lets the brick breathe while blocking bulk water.
- Flue relining: $2,400 – $4,800 for a full stainless reline on a typical Houston two-story home, depending on liner diameter and access.
What moves the price: chimney height, roof pitch, whether we’re on a ladder or need a lift, and what the camera shows inside. You’ll know your number before we start. Call (325) 750-6259 for a free estimate on your specific Olympia chimney repair.
See the difference
Before
After
Before
After
Before
AfterWhy Houston Homeowners Call Flint Chimney Co Houston for Olympia Chimney Work
We’ve been a Garrison Partners company since 2002, and the Garrison Standard runs on one rule: put everything in writing before the first tool comes off the truck. Price, scope, and the one-year guarantee. Every Olympia chimney repair in Houston we perform carries the 365-Day Done Right Promise. If it’s not done right, we make it right, in writing, at no charge.
Our techs are background-checked and uniformed, so you know exactly who’s at your door. We answer the phone 24/7 with a live person. And because not every repair calls for an Olympia-branded part, we work with the full shelf of professional-grade materials: DuraFlex liners, HeatShield resurfacing systems, Gelco products, Famco caps, and Copperfield flashing. We specify by job, not by margin. Tell me what you’re seeing, I’ll tell you what it costs to fix it.
Olympia Chimney Repair FAQs
No. We are an independent Olympia Chimney service provider. We repair and maintain Olympia chimney products in Houston, but we are not affiliated with or authorized by Olympia Chimney. What that means for you: we have no incentive to push a manufacturer’s agenda. We’ll tell you when an Olympia part is the right call and when a quality alternative does the job better for less.
In most cases, no. Repairs we make to the chimney structure (flashing, crown, masonry) typically fall outside OEM warranty coverage on Olympia prefab units anyway because the warranty covers the factory components, not the installation envelope around them. If a repair involves an Olympia-warranted part, we’ll flag that before proceeding so you can decide whether to file a warranty claim first. Call (325) 750-6259 and we’ll walk you through what applies to your specific unit.
Most Olympia chimney repairs we handle are completed in one visit within a week of your call. Weather-dependent work, like waterproofing, needs a dry window, and Houston rain can push that out a few days. We’ll tell you the schedule at the time of booking and show up when we say we will.
If the prefab chimney chase and firebox are structurally sound, repair almost always makes more sense than replacement. We’ve repaired Olympia units in Houston that were 30 years old, and they still had years of service left. Replacement becomes the only honest answer when rust has compromised the chase framing or the firebox is warped beyond safe operation. We’ll show you the camera footage and you make the call with facts in hand.
Yes. Our Houston crews work with DuraFlex, HeatShield, and Gelco products regularly, along with Famco and Copperfield components. If your home has mixed-brand chimney equipment, we can service the whole system in one visit. Call (325) 750-6259 for an estimate on any chimney repair in Houston.
Get Your Olympia Chimney Repair Priced in Writing
If you own an Olympia Chimney product in the Houston area and something isn’t right, call (325) 750-6259. A live person answers, we schedule a visit, and we hand you a written price before any work begins. Free estimate, no obligations, and a one-year written guarantee on every repair. Hank Delano and the Flint Chimney Co Houston crew have been keeping Houston chimneys safe and dry for over a decade.
Written by Hank Delano, Owner, Flint Chimney Co Houston at Flint Chimney Co Houston, serving Houston and nearby areas.